source: MML/trunk/machine/THOMX/readme @ 35

(1) Files need to update with the real machine:

Needs to active all links with TANGO...

 --15/11/2013 

  
/common/cycling/*
   Thomxinit.m; setoperationmode.m;
   Magnetcoefficients.m; k2amp.m; amp2k.m; bend2gev.m; gev2bend.m






(2) 17/12/2013
 .../mml/setpathmml.m

correct with the Tango of ThomX...

case 'TANGO'

************


**********************************************
24/02/2014  Jianfeng Zhang @ LAL

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
NEED TO take a lot of time & special attentions 
            to configure:  "magnetcoefficients.m",

also need to check "bend2gev.m" & "gev2bend.m".

 
!!!!!&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&
---- There are two types of dipoles in the transfer line (TL),
     BEND1, BEND2, (different length and bending angle.),
     so there will be two type of B---> I.
!!!!!!&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&

----- The magnetic field strength of dipoles in the ring are 
      the same as BEND1 in TL.



**********************************************
---- 05/03/2014
       In AT model, the TL dipoles are set up and read back
       by the physics units [rad].
       While the storage ring dipoles are set up and read 
       back by the beam energy through "bend2gev.m" & "gev2bend.m". 
      
      The set up and read back of the TL dipoles needs to be 
      checked in the connections through Tango. 
  

----    Need to check the basic values setting using MML 
        through TANGO: 
 
         setsp(), getsp() 

         dipole, quadrupole, sextupole, kicker, BPM, etc.

----   Set element properties using CHANEL names through TANGO.


----
09/04/2014 
(1)
    Test the machine mode in TLinit.m & thomxinit.m

This is a very important command!!!!!!!!!!!


(2) Need to set the crunch & roll parameters of BPMs in the future...

-----